Putting the Pieces Together
Attaching the System Console
Connect the RS-232 serial cable (provided) to an ASCII terminal. The cable is
approximately 10 feet (3 meters) long. Plug the D-shaped, 9-pin connector into serial port
1 on the back of the system, as shown in Figure 2-18.
Figure 2-18
Attaching the Serial Cable
Connect the other end of the serial cable, which has a D-shaped, 25-pin connector, to a
serial (ASCII) terminal.
You can use a computer, such as an IBM-compatible or Macintosh, or a workstation, such
as a Silicon Graphics O2 or Indy, as the system console instead of an ASCII terminal. For
more information, see "Using Another Computer or Workstation as the System Console"
in Chapter 4.
51