Installing 3.5-Inch Drives - Silicon Graphics Origin200 Owner's Manual

Chapter 2: Setting Up an Origin200 System
38
4. If you are installing the Origin200 modules in an equipment rack, turn now to
Chapter 3, "Installing an Origin200 System in a Rack."
Follow the instructions for installing the Origin200 module in an equipment
rack.
When you are finished installing the module in the equipment rack, return to
"Attaching an Ethernet Networking Cable," in this chapter.
5. If you are installing a tower (free-standing) Origin200 server, place it in the location
you determined earlier (see "Choosing a Location for the Server" on page 30).

Installing 3.5-Inch Drives

After you have placed the server in the desired location (either in a free-standing, tower
configuration or mounted in an equipment rack), install any option drives.
All 3.5-inch drives shipped from Silicon Graphics for use in Origin200 systems are
attached to mounting sleds. The SCSI ID of the drive is set automatically when it is
installed in the system. The bottom 3.5-inch drive slot (rightmost slot in a rack system) is
drive ID 1, and the top 3.5-inch drive slot (leftmost slot in a rack system) is drive ID 6. See
Figure 2-6.