Removing The Feet And Exterior Plastic Parts; Figure 5-7 Removing The Top Cap - Silicon Graphics Origin200 Owner's Manual

Chapter 5: Origin200 Cosmetic Features and Covers
122

Removing the Feet and Exterior Plastic Parts

Follow these steps to remove the feet, top cap, and lower bezel:
1. Remove the top cap, as shown in Figure 5-7.
Insert a flat-blade screwdriver between the top cap and sheet metal, as shown in
Figure 5-7.
Twist the screwdriver while pulling the top cap forward. The top cap should
move forward slightly as one side disengages from the sheet metal.
Repeat this step on the opposite side of the top cap, as shown in Figure 5-7.
When the second side of the top cap disengages from the sheet metal, pull the
top cap forward, then lift it up and off of the chassis.
Figure 5-7 Removing the Top Cap