Power Supply; Table 1-4 Origin200 Server Power Supply Specifications (Per Module) - Silicon Graphics Origin200 Owner's Manual

Power Supply

Specifications of the Origin200 power supply are as follows:
Table 1-4 Origin200 Server Power Supply Specifications (per Module)
Specification Value
Input volts 100 to 120 VAC, and 200 to 240 VAC, autoranging
Input watts 805 watts (for a fully configured module)
Input amps 8 amps at 100 VAC
4 amps at 240 VAC
Input volt-amps 800 VA
Inrush current 140 amps maximum
Frequency 47 Hz to 63 Hz
Output volts +5 VDC
+12 VDC
-12 VDC
+3.45 VDC
Output watts 483 watts (for a fully configured system)
Power factor Unity power-factor corrected (0.98)
Efficiency 60%
Warning:
When using an uninterruptable power supply (UPS) with an Origin200
server, be sure that the UPS can supply up to 140 A of inrush current. Each Origin200
module can draw up to 140 A of current briefly when you power it on, even though the
sustained current drawn is only a fraction of that. Some UPS units cannot supply that
much inrush current and will be damaged if you use them with an Origin200 server.
In addition, there is the possibility of fire or other hazard if these UPS units are unable
to supply sufficient current.

Power Supply

21