Figure 8-3 Removing A Blanking Plate And The Rear Access Plate - Silicon Graphics Origin200 Owner's Manual

Removing a Blanking Plate and the Rear Access Plate From the Peripheral Carrier
Figure 8-3
4. Slide the drive into the peripheral carrier and attach it with four screws through the
side of the carrier, as shown in Figure 8-4.
5. Attach the power and SCSI connectors at the rear of the carrier to the drive. Use
whichever connectors fit conveniently for the position of the drive in the carrier.
6. Replace the access plate. See Figure 8-4.
Be sure to reinstall the access plate on the rear of the carrier. The plate protects
Note:
the power and SCSI cables from damage when you slide the carrier into the system.
Installing, Removing, and Configuring 5.25-Inch Peripherals
Front
Rear
163