Figure 2-15 Replacing The Rear Access Plate On The Peripheral Carrier - Silicon Graphics Origin200 Owner's Manual

Chapter 2: Setting Up an Origin200 System
48
7. Replace the access plate. See Figure 2-15.
The plate should cover all of the loose wires (power and SCSI) at the rear of the
carrier.
Rear
Replacing the Rear Access Plate on the Peripheral Carrier
Figure 2-15
Be sure to reinstall the access plate on the rear of the carrier. The plate protects
Note:
the power and SCSI cables from damage when you slide the carrier into the system.