Installing, Removing, and Configuring 3.5-Inch Peripherals
8. Replace the front door.
You are finished removing the 5.25-inch peripheral.
Installing, Removing, and Configuring 3.5-Inch Peripherals
The Origin200 chassis has room for six 3.5-inch peripherals. Each peripheral is mounted
on a sled to make it convenient to install and remove, and set their SCSI ID numbers.
The next sections describe how to configure, install, and remove 3.5-inch peripherals.
About the 3.5-Inch Peripheral Bay
The 3.5-inch peripheral bay holds up to six drives mounted on sleds. The SCSI ID of each
drive is determined by the slot into which it is installed. The system (boot) disk must be
installed in slot 1. Figure 8-11 shows how the slots correspond to SCSI IDs.
171