Installing And Configuring Peripherals; Installing, Removing, And Configuring 5.25-Inch Peripherals - Silicon Graphics Origin200 Owner's Manual

8.
Installing, Removing, and Configuring 5.25-Inch Peripherals
Chapter 8
Installing and Configuring Peripherals
This chapter describes how to install and configure peripherals, including 5.25-inch and
3.5-inch drives and serial devices:
• "Installing, Removing, and Configuring 5.25-Inch Peripherals" on page 159
• "Installing, Removing, and Configuring 3.5-Inch Peripherals" on page 171
• "Verifying That a Drive Is Installed Correctly" on page 179
• "Using Drives In the Origin200 Server" on page 179
• "Attaching Serial Devices" on page 181
This chapter also directs you to additional documentation about using peripherals with
your Origin200 system.
The following sections describe how to configure, install, and remove peripherals from
the 5.25-inch drive bay:
• "About the 5.25-Inch Peripheral Bay" on page 160
• "Configuring a 5.25-Inch Peripheral" on page 161
• "Installing a 5.25-Inch Peripheral" on page 161
• "Removing 5.25-Inch Peripherals" on page 166
159