Chapter 10: Removing and Replacing Internal Components
Miscellaneous Fasteners
Removing and Replacing Internal Parts
198
The following miscellaneous fasteners are used in the Origin200 server:
•
plastic rivets to attach the fans to the fan bulkhead; spare rivets are included with
replacement fans from Silicon Graphics
•
screws, Phillips, 6-32 x 1/4-inch, for internal components and attaching rack ears to
a rackmount system
•
screws, Phillips, 10-32 x 1/2-inch, for attaching a rackmount system to an
equipment rack
•
washers, #10 (.203 ID x .562 OD x .040 inch thick), for use with 10-32 x 1/2-inch
screws in rackmounting
This section describes how to remove and install the following internal parts of the
Origin200 server:
•
SCSI backplane
•
fans
•
logic carrier
•
power supply
•
system controller
Procedures to remove and replace the following components are described in other
chapters in this guide:
•
Memory is described in Chapter 6, "Installing and Removing Memory."
•
PCI boards are described in Chapter 7, "Installing and Removing PCI Option
Boards."
•
3.5-inch and 5.25-inch peripherals are described in Chapter 8, "Installing and
Configuring Peripherals."