Using The Aux Port And Module System Controller Commands; Figure 4-7 Location Of The Aux Port - Silicon Graphics Origin200 Owner's Manual

Chapter 4: Operating an Origin200 System

Using the AUX Port and Module System Controller Commands

98
The AUX port is an 8-pin mini-DIN connector at the rear of the Origin200 server that
connects to the module system controller (MSC). Figure 4-7 shows the location of the
AUX port.
Location of the AUX Port
Figure 4-7
The AUX port uses a standard, RS-232 interface, and the pin assignments are identical to
those used on Silicon Graphics Indy and Indigo
S server. (See Appendix A, "Connector Pinout Assignments.") However, you cannot use
the Origin200 AUX port to log in to IRIX.
AUX port
2
workstations and the CHALLENGE®