Turning Off The System - Silicon Graphics Origin200 Owner's Manual

4. At the System Maintenance Menu, type
The Origin200 server starts booting IRIX.
You should see various messages, followed by the login prompt:
IRIS login:
When you see the "login" prompt, the system is finished booting and it is ready
to use.

Turning Off the System

When you turn off the system, you can either:
• turn the system off, but leave the system controller active (for example, if you want
to turn the system on remotely through the AUX port)
• turn off all power to the system (for example, if you are servicing internal
components, replacing drives, or moving the system)
Follow these steps to turn off the system:
1. Log in to the system as root.
2. Verify that no one is using the system, or that it is not in the middle of a critical task.
3. At a shell prompt, enter this command:
/etc/shutdown -g0
This causes the system to begin shutting down immediately. See shutdown(1M) for
more information.
You see various messages about the system shutting down, then you see the System
Maintenance Menu:
Running power-on diagnostics...
System Maintenance Menu
1) Start System
2) Install Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor
Option?
Turning the System On and Off
and press .
1 Enter
83