Connecting The Power Cord; Connecting The Ac Power Cord For The Fixed Ac Power Supply - HP FlexNetwork 5140 EI Series Installation Manual

Figure 20 Removing a power supply
1
2

Connecting the power cord

CAUTION:
• Provide a circuit breaker for each power cord.
• Before connecting the power cord, make sure the circuit breaker on the power cord is turned off.
Table 7 Power cord connection procedures at a glance
Switch model
HPE 5140 24G PoE+
4SFP+ EI
HPE 5140 48G PoE+
4SFP+ EI
HPE 5140 24G SFP w/8G
Combo 4SFP+ EI
Other HPE 5140 EI
switches
The HPE 5140 24G SFP w/8G Combo 4SFP+ EI switches use removable power supplies. The
PSR150-A1 and PSR150-D1 power supplies are available for the switch. The PSR150-A1 power
supply uses AC power. The PSR150-D1 power supply uses –48 VDC power or RPS power.

Connecting the AC power cord for the fixed AC power supply

1. Connect the plug of the AC power cord to the AC-input power receptacle on the switch. See
Figure
2. Use a cable tie to secure the power cord to the handle near the AC power receptacle. See
Figure
3. Connect the other end of the power cord to an AC power source.
Available power source
AC power source
RPS1600-A
AC power source
–48 VDC power source in the
equipment room
RPS800-A or RPS1600-A
AC power source
21.
22.
1
18
Connection procedure reference
Connecting the AC power cord for the fixed
AC power supply
Connecting the DC power cord for the fixed
DC power supply
Connecting the power cord for a
PSR150-A1
Connecting the power cord for a
PSR150-D1
Connecting the power cord for a
PSR150-D1
Connecting the AC power cord for the fixed
AC power supply