Protocol Configuration; Enabling Applications; Figure 3-59: Applications Enabling - AudioCodes Mediant 2000 User Manual

3.3.7

Protocol Configuration

The Protocol Configuration menu allows you to configure the device's SIP parameters
and contains the following submenus:

Applications Enabling (refer to "Enabling Applications" on page 96)

Media Realms (refer to "Configuring Media Realms" on page 97)

Protocol Definition (refer to ''

Proxies/IpGroups/Registration (refer to ''Proxies, IP Groups, and Registration''
101 )

Coders And Profile Definitions (refer to ''Coders and Profile Definitions''

SIP Advanced Parameters (refer to ''SIP Advanced Parameters''

SAS (refer to "SAS Parameters" on page 124)

Manipulation Tables (refer to ''

Routing Tables (refer to ''Routing Tables''

Trunk Group (refer to ''Trunk Groups''

Digital Gateway (refer to "Configuring the Digital Gateway Parameters" on page 160)
3.3.7.1

Enabling Applications

The 'Applications Enabling' page allows you to enable the following applications:

SAS application

IP-to-IP (IP2IP) application
Notes:

To enable an application:
1. Open the 'Applications Enabling' page (Configuration tab > Protocol Configuration
menu > Applications Enabling page item).
2. Save the changes to the device's flash memory and reset the device (refer to ''Saving
Configuration''
SIP User's Manual
Protocol Definition''
Manipulation Tables''
•
This page displays the application only if the device is installed with the
relevant Feature Key supporting the application (refer to "Loading a
Software Upgrade Key" on page 176).
•
For enabling an application, a device reset is required.
Figure 3-59: Applications Enabling Page
on page 173 ).
on page 98
on page
on page 136 )
on page 154 )
96
Mediant 2000
)
on page
on page 114
on page 122 )
129 )
Document #: LTRT-68809
)