Configuration Parameters Reference; Networking Parameters; Ethernet Parameters; Table 6-1: Ethernet Parameters - AudioCodes Mediant 2000 User Manual

SIP User's Manual
6

Configuration Parameters Reference

The device's configuration parameters, default values, and their description are
documented in this section.
Parameters and values enclosed in square brackets ([...]) represent ini file parameters and
their enumeration values; parameters not written in square brackets represent their
corresponding Web interface and/or EMS parameters.
Note:
6.1

Networking Parameters

This subsection describes the device's networking parameters.
6.1.1

Ethernet Parameters

The Ethernet parameters are described in the table below.
Parameter
EMS: Physical Configuration
[EthernetPhyConfiguration]
Web: Enable LAN Watchdog
[EnableLanWatchDog]
Version 5.8
Some parameters are configurable only through the ini file.

Table 6-1: Ethernet Parameters

Defines the Ethernet connection mode type.

[0] = 10Base-T half-duplex

[1] = 10Base-T full-duplex

[2] = 100Base-TX half-duplex

[3] = 100Base-TX full-duplex

[4] = Auto-negotiate (default)
For detailed information on Ethernet interface configuration, refer to
Ethernet Interface Configuration on page 447.
Note: For this parameter to take effect, a device reset is required.
Determines whether the LAN Watch-Dog feature is enabled

[0] Disable = Disable LAN Watch-Dog (default).

[1] Enable = Enable LAN Watch-Dog.
When LAN Watch-Dog is enabled, the device's overall
communication integrity is checked periodically. If no communication
is detected for about three minutes, the device performs a self test:

If the self test succeeds, the problem is a logical link down (i.e.,
Ethernet cable disconnected on the switch side), and the Busy
Out mechanism is activated if enabled (i.e., parameter
EnableBusyOut is set to 1).

If the self test fails, the device restarts to overcome internal fatal
communication error.
6. Configuration Parameters Reference
Description
223
.
October 2009