Configuring The Ip Routing Table; Figure 3-38: Ip Routing Table Page; Table 3-11: Ip Routing Table Description - AudioCodes Mediant 2000 User Manual

3.4.1.5

Configuring the IP Routing Table

The 'IP Routing Table' page allows you to define up to 50 static IP routing rules for the
device. For example, you can define static routing rules for the OAMP and Control networks
since a default gateway is supported only for the Media traffic network (refer to ''Configuring
the Multiple Interface Table'' on page 53). Before sending an IP packet, the device
searches this table for an entry that matches the requested destination host / network. If
such an entry is found, the device sends the packet to the indicated router. If no explicit
entry is found, the packet is sent to the default gateway (configured in the 'IP Settings'
page-- refer to ''Configuring the IP Settings'' on page 50).
To configure static IP routing, take these 3 steps:
Open the 'IP Routing Table' page (Configuration tab > Network Settings menu > IP
1.
Routing Table page item).
In the 'Add a new table entry' group, add a new static routing rule according to the
2.
parameters described in the table below.
Click Add New Entry; the new routing rule is added to the IP routing table.
3.
To delete a routing rule from the table, select the 'Delete Row' check box that corresponds
to the routing rule entry, and then click Delete Selected Entries.
Parameter
Destination IP Address
[RoutingTableDestinationsColumn]
Destination Mask
[RoutingTableDestinationMasksColumn]
SIP User's Manual

Figure 3-38: IP Routing Table Page

Table 3-11: IP Routing Table Description

Specifies the IP address of the destination host /
network.
Specifies the subnet mask of the destination host /
network.
62
Mediant 2000
Description
Document #: LTRT-68808