SIP User's Manual
To configure Coder Groups:
1.
Open the 'Coder Group Settings' page (Configuration tab > VoIP menu > Coders
And Profiles submenu > Coders Group Settings).
2.
From the 'Coder Group ID' drop-down list, select a Coder Group ID.
3.
From the 'Coder Name' drop-down list, select the first coder for the Coder Group.
4.
From the 'Packetization Time' drop-down list, select the packetization time (in msec)
for the coder. The packetization time determines how many coder payloads are
combined into a single RTP packet.
5.
From the 'Rate' drop-down list, select the bit rate (in kbps) for the coder you selected.
6.
In the 'Payload Type' field, if the payload type (i.e., format of the RTP payload) for the
coder you selected is dynamic, enter a value from 0 to 120 (payload types of 'well-
known' coders cannot be modified).
7.
From the 'Silence Suppression' drop-down list, enable or disable the silence
suppression option for the coder you selected.
8.
Repeat steps 3 through 7 for the next coders (optional).
9.
Repeat steps 2 through 8 for the next coder group (optional).
10.
Click the Submit button to save your changes.
11.
To save the changes to flash memory, see ''Saving Configuration'' on page 197.
3.3.2.10.3 Configuring Tel Profile
The 'Tel Profile Settings' page allows you to define up to nine Tel Profiles. You can assign
these Tel Profiles to the device's channels in the Trunk Group Table (see Configuring the
Trunk Group Table on page 139)), and thereby, apply different behaviors to different
channels.
Note:
Version 6.2
Figure 3-90: Coder Group Settings Page
You can also configure Tel Profiles using the ini file table parameter TelProfile
(see SIP Configuration Parameters).
135
3. Web-Based Management
February 2011