Concluding Steps; Software Configuration - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

System board and components

14.2.3.5 Concluding steps

Perform the following procedures to complete the task:
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page

14.2.3.6 Software configuration

The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.
436
"Mounting the side cover" on page 85
92.
Upgrade and Maintenance Manual
87.
"Connecting the server to the mains" on
110.
116.
"Mounting the top cover"
(tower
89.
"Closing the rack
"Enabling SVOM
"Enabling
TX140 S1