Removing A 2.5-Inch Hdd / Ssd Module - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
http://manuals.ts.fujitsu.com
http://jp.fujitsu.com/platform/server/primergy/manual/
market).
Ê If applicable, open the rack door as described in section
door" on page
Ê When working on a tower server, open the HDD bay cover as described in
section "Removing the HDD bay cover" on page
7.2.3.3

Removing a 2.5-inch HDD / SSD module

Figure 69: Disconnecting a 2.5-inch HDD / SSD module
Ê Pinch the green locking clips (1) and fully open the locking lever (2).
I
Thereby, the HDD / SSD module is pushed out of its drive bay by
about 1 cm and disconnected from the SAS / SATA backplane.
Ê Wait about 30 seconds to allow the hard disk drive to spin down.
I
This is not necessary when removing a solid state drive.
168
61.
Upgrade and Maintenance Manual
(EMEA market) or
76.
(Japanese
"Opening the rack
TX140 S1