Concluding Steps; On Page - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
Figure 126: Connecting the BBU to the controller
Ê Run the BBU cable through the cable clamp next to the HDD cage as shown
(1).
Ê Connect the BBU cable to the RAID controller (2).
I
The connector side with the three dots points towards you.
9.3.1.5

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section

on page

209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
252
"Mounting the side cover" on page 85
Upgrade and Maintenance Manual
"Installing the fan module"
"Mounting the top cover"
(tower
TX140 S1