Installing An Expansion Card - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.2.1.4

Installing an expansion card

Ê Remove the expansion card from its protective packaging.
I
For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section
Figure 111: Installing the expansion card (A)
Ê Carefully insert the expansion card into the desired PCI slot and press down
firmly until it is fully seated in the slot.
I
Slot 3 is the preferred slot for SAS RAID controllers.
230
"Mounting expansion card slot brackets" on page
Upgrade and Maintenance Manual
276.
TX140 S1