Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

10.2.4 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê If available, update the system board BIOS to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 100.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If applicable, configure the memory mode as described in section
the memory mode" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX140 S1
"Mounting the side cover" on page 85
92.
111.
Upgrade and Maintenance Manual
"Installing the fan module"
87.
"Connecting the server to the mains" on
110.
116.
Main memory
"Mounting the top cover"
(tower
89.
"Closing the rack
"Enabling SVOM
"Verifying
"Enabling
299