Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual page 101

Ê After completion of the flash process, remove the USB stick and restart the
server.
BIOS recovery procedure
I
For the Japanese market, follow the instructions provided separately.
Ê Prepare a USB stick with the following files:
– Update tool
– Startup.nsh (which will execute the update tool)
– BIOS image file for update (16 MB with header information)
Ê Ensure that the server has been shut down and disconnected from the
mains as described in section
Ê Open the side / top cover as described in section
page 67.
Ê Enter BIOS recovery mode using the onboard jumpers.
I
For detailed information on jumper settings, refer to section
settings" on page
Ê Close the side / top cover as described in section
page 77.
Ê Connect the USB stick to the USB port.
Ê Connect the server to the mains as described in section
server to the mains" on page
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V
CAUTION!
Do not interrupt the BIOS recovery process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side / top cover as described in section
page 67.
Ê Disable BIOS recovery mode using the onboard jumpers:
TX140 S1
"Shutting down the server" on page
577.
90.
Upgrade and Maintenance Manual
Basic software procedures
"Opening the server" on
"Closing the server" on
"Connecting the
"Opening the server" on
61.
"Onboard
101