System board and components
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
14.2.3 Replacing the UFM board
Field Replaceable Units (FRU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
14.2.3.1 Required tools
Preliminary and concluding steps:
●
– combination pliers and flat nose pliers
Replacing the UFM:
●
– Phillips PH1 / (+) No. 1 screw driver
14.2.3.2 Preliminary steps
Before replacing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
61.
430
93.
61.
54.
Upgrade and Maintenance Manual
116.
94.
"Shutting down the server" on
"Enabling
"Disabling BitLocker
"Disabling
"Opening the rack
"Locating the defective
TX140 S1