Hard disk drives / solid state drives
7.3.3.4
Installing a 3.5-inch HDD dummy module
V
CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 80: Installing a 3.5-inch HDD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.3.3.5
Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section
"Installing the HDD bay cover" on page
Ê If applicable, close the rack door as described in section
door" on page
182
92.
Upgrade and Maintenance Manual
84.
"Closing the rack
TX140 S1