Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.2.4.5

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 117.
Ê After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
244
"Mounting the side cover" on page 85
92.
"Looking up changed MAC / WWN addresses"
"Updating RAID controller firmware" on page
Upgrade and Maintenance Manual
"Installing the fan module"
87.
"Connecting the server to the mains" on
110.
116.
"Mounting the top cover"
(tower
89.
"Closing the rack
111.
"Enabling SVOM
"Enabling
TX140 S1
114.
105.