Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Figure 181: Installing the heat sink (B)
Ê Fasten the four captive screws on the heat sink in a crossover pattern (screw
torque: 0.6 Nm, not applicable for the Japanese market) (1-4).

11.2.8 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
TX140 S1
"Mounting the side cover" on page 85
Upgrade and Maintenance Manual
Processors
"Installing the fan module"
"Mounting the top cover"
89.
(tower
323