Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.2.1.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 106.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
232
"Mounting the side cover" on page 85
92.
"Updating RAID controller firmware" on page
Upgrade and Maintenance Manual
"Installing the fan module"
87.
"Connecting the server to the mains" on
"Enabling Option ROM scan" on
110.
116.
"Mounting the top cover"
(tower
89.
"Closing the rack
"Enabling SVOM
"Enabling
120.
TX140 S1
105.