Removing Expansion Cards; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

9.2.2

Removing expansion cards

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
9.2.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Removing expansion cards: tool-less
●
9.2.2.2

Preliminary steps

Before removing an expansion card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Remove all external cables from the expansion card to be removed.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
TX140 S1
93.
61.
54.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
Upgrade and Maintenance Manual
Expansion cards and backup units
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
66.
"Removing the top cover"
"Opening the rack
63.
65.
(tower
233