Installing An Expansion Card; Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Remove the defective expansion card as described in section
expansion cards" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
brackets" on page
9.2.3.4

Installing an expansion card

Ê If applicable, install a slot bracket on the new expansion card as described
in section "Mounting expansion card slot brackets" on page
Ê Install the new expansion card as described in section
cards" on page
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section
page 284.
9.2.3.5

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overview" on page
9.2.3.6

Connecting a battery backup unit to the expansion card

Ê If applicable, connect a BBU to the expansion card as described in section
"Installing a BBU" on page
9.2.3.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
240
233.
276.
226.
"Installing SFP+ transceiver modules" on
490.
245.
"Mounting the side cover" on page 85
Upgrade and Maintenance Manual
"Mounting expansion card slot
"Installing expansion
"Installing the fan module"
"Mounting the top cover"
89.
"Removing
276.
"Cabling
(tower
TX140 S1