Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Cabling

16.6.2 Preliminary steps

Before replacing the power cable, perform the following steps:
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
540
61.
54.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
Upgrade and Maintenance Manual
"Opening the rack
"Locating the defective
"Shutting down the server" on
66.
"Removing the top cover"
63.
65.
(tower
TX140 S1