Power supply
6.3.2.2
Preliminary steps
Before replacing the PSU module, perform the following steps:
Ê Only when replacing a power supply module in a non-redundant
configuration: Disable BitLocker functionality as described in section
"Disabling BitLocker functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Only when replacing a power supply module in a non-redundant
configuration: Shut down the server as described in section
the server" on page
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
6.3.2.3
Removing the power supply module
Figure 58: Removing the power supply module
Ê Fold up the handle on the PSU module (1).
Ê Press in on the green locking latch (2).
Ê While keeping the green locking latch pressed, pull the PSU module out of
its slot (3).
150
61.
54.
61.
"Disconnecting power cords" on page
Upgrade and Maintenance Manual
93.
"Opening the rack
"Locating the defective
"Shutting down
63.
TX140 S1