Removing The System Board - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
Ê Remove the fan module as described in section
on page 208.

14.4.3 Removing the system board

Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see
I
Leave the processor on the defective board for now.
– Memory modules: refer to section
page 300
I
Ensure to take note of the memory modules' mounting positions
for reassembly.
– Expansion cards: refer to the section
page 233
I
Ensure to take note of the controllers' mounting positions and
cable connections for reassembly.
– UFM board: refer to section
I
Remove the UFM spacer from the defective system board and
fasten it with the UFM screw to the UFM board.
TX140 S1
"Removing the side cover" on page 71
section "Removing the processor heat sink" on page 310
"Removing the UFM board" on page 426
Upgrade and Maintenance Manual
System board and components
"Removing the top cover"
"Removing the fan module"
"Removing memory modules" on
"Removing expansion cards" on
(tower
455