Replacing A 2.5-Inch Hdd / Ssd Module; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

7.2.4

Replacing a 2.5-inch HDD / SSD module

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
V
CAUTION!
Only remove an HDD / SSD module during operation if the drive is
●
not currently being accessed. Observe the indicators for the
corresponding HDD / SSD modules, see "PRIMERGY TX140 S1
Server - Operating manual".
Under no circumstances should you remove an HDD / SSD module
●
while the system is in operation if you are not sure that the drive is
operated by a RAID controller and belongs to a disk array that is
operating in RAID level 0, 1, 1E, 10, 5, 50, 6 or 60.
An HDD / SSD module can only be replaced during operation in
conjunction with a corresponding RAID configuration.
All HDD / SSD modules (drives) must be uniquely identified so that
●
they can be reinstalled in their original mounting locations later. If this
is not done, existing data can be lost.
7.2.4.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing a 2.5-inch HDD / SSD module: tool-less
●
7.2.4.2

Preliminary steps

Before replacing a 2.5-inch HDD / SSD module, perform the following steps:
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the defective server as described in section
server" on page
Ê When working on a tower server, open the HDD bay cover as described in
section "Removing the HDD bay cover" on page
TX140 S1
61.
54.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Locating the defective
76.
"Opening the rack
171