Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Figure 260: Connecting front panel cables
Ê Run the front panel cable through the cable clamps (see orange arrows) as
shown (1).
Ê Connect the front panel cable
FRONTPANEL (2).

13.2.2.6 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the front cover and reinstall the ID card as described in section
"Mounting the rack front cover" on page 77
front cover" on page 82
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
TX140 S1
T26139- Y4015-V1 to system board connector
(tower server).
"Mounting the side cover" on page 85
Upgrade and Maintenance Manual
Front panel and external connectors
"Installing the fan module"
(rack server) or
"Mounting the top cover"
89.
"Mounting the
(tower
407