Replacing Expansion Cards; Required Tools - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
9.2.3

Replacing expansion cards

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
Note on network settings recovery
I
The following note is required for TX140 S1p (PYT14Pxxx for Japanese
market).
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.2.3.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing expansion cards: tool-less
●
Mounting slot brackets:
●
– Phillips PH2 / (+) No. 2 screw driver
238
92.
Upgrade and Maintenance Manual
"Connecting the server to the mains" on
116.
"Closing the rack
"Enabling
TX140 S1