Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Figure 303: Installing the protective socket cover (defective system board) (C)
Ê Latch the socket lever under the load plate tab.

14.4.5 Concluding steps

Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section
page 321
– Memory modules: refer to section
page 297
I
Install all memory modules into their original slots.
– Expansion cards: refer to section
page 297
I
Install all expansion cards into their original slots.
– UFM board: refer to section
– TPM board (if applicable): refer to section
board" on page 437
TX140 S1
"Cabling overview" on page
"Installing the processor heat sink" on
"Installing the UFM board" on page 422
Upgrade and Maintenance Manual
System board and components
490.
"Installing a memory module" on
"Installing a memory module" on
section "Installing the TPM
469