Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

I
– Use the first holes in the bottom or top row of the perforated rail
as shown.
– Use the screws which are provided with the packaging contents of
the backup drive.
Ê Install the new ODD as described in section
page 344.

12.4.6 Concluding steps

Perform the following procedures to complete the task:
Ê Close the front cover and reinstall the ID card as described in section
"Mounting the rack front cover" on page 77
front cover" on page 82
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX140 S1
(tower server).
"Mounting the side cover" on page 85
92.
Upgrade and Maintenance Manual
"Installing a backup drive" on
(rack server) or
87.
"Connecting the server to the mains" on
116.
Accessible drives
"Mounting the
"Mounting the top cover"
(tower
89.
"Closing the rack
107.
"Enabling
369