Removing A Fbu; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.4

Removing a FBU

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
V
CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
protection" in the PRIMERGY TX140 S1 Server Operating Manual.
9.3.4.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing a FBU: tool-less
●
9.3.4.2

Preliminary steps

Before removing a FBU, perform the following steps:
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
264
61.
54.
61.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
"Opening the rack
"Locating the defective
"Shutting down the
66.
63.
65.
TX140 S1