Hard disk drives / solid state drives
7.2.2.2
Preliminary steps
Before installing a 2.5-inch HDD / SSD module, perform the following steps:
Ê If applicable, open the rack door as described in section
door" on page
Ê When working on a tower server, open the HDD bay cover as described in
section
"Removing the HDD bay cover" on page
Ê Locate the correct drive bay as described in section
inch HDDs / SSDs" on page
7.2.2.3
Removing a 2.5-inch HDD / SSD dummy module
Figure 65: Removing a 2.5-inch dummy module
I
Dummy modules have been installed into unused HDD / SSD bays.
Before installing an additional HDD / SSD, the dummy module needs to
be removed from the desired drive bay.
Ê Press in on the locking clips on left side of the dummy module to disengage
the locking mechanism (1).
164
61.
161.
Upgrade and Maintenance Manual
"Opening the rack
76.
"Mounting order for 2.5-
TX140 S1