Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual page 186

Hard disk drives / solid state drives
Ê When working on a tower server, open the HDD bay cover as described in
section "Removing the HDD bay cover" on page
Ê Remove all HDD / SSD modules from the server as described in section
"Removing 2.5-inch HDD / SSD modules" on page
V
CAUTION!
Ensure that all hard disk drives are uniquely identified so that you can
reinsert them into their original bays after replacing the HDD
backplane.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
186
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
Upgrade and Maintenance Manual
76.
167.
66.
"Removing the top cover"
65.
(tower
TX140 S1