Installing A New Bbu; Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.5.5

Installing a new BBU

Ê Install the new BBU into the BBU holder as described in section
the BBU" on page
Ê Install the BBU holder into the chassis as described in section
BBU holder into the chassis" on page
Ê Connect the BBU to the controller.
9.3.5.6

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê If applicable, update the firmware of the RAID controller that has been
connected to the BBU as described in section
firmware" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
270
246.
"Mounting the side cover" on page 85
92.
105.
Upgrade and Maintenance Manual
249.
"Installing the fan module"
"Mounting the top cover"
87.
"Connecting the server to the mains" on
"Updating RAID controller
110.
"Preparing
"Installing the
(tower
89.
"Closing the rack
"Enabling SVOM
TX140 S1