Displaying And Maintaining Link Aggregation Configuration - H3C S7500 Series Operation Manual

Operation Manual – Link Aggregation
H3C S7500 Series Ethernet Switches
Enter Ethernet port view
Enable LACP on the port
Configure the port priority
Note:
If you use the save command to save the current configuration and then restart the
device, the configured manual/static aggregation groups and their descriptions still
exist, however, the dynamic aggregation groups will disappear and their descriptions
cannot be restored.
1.3 Displaying and Maintaining Link Aggregation
Configuration
Display summary
information of all
aggregation groups
Display detailed
information of a specific
aggregation group
Display the ID of the local
device
Display link aggregation
details of a specified port
or port range
Clear LACP statistics
about a specified port or
port range
To do...
interface interface-type
interface-number
lacp enable
lacp port-priority
port-priority
To do...
display link-aggregation
summary
display link-aggregation verbose
agg-id
display lacp system-id
display link-aggregation
interface interface-type
interface-number | [ to
{ interface-type interface-number ]
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
Chapter 1 Link Aggregation Configuration
Use the command...
Use the command...
1-11
Remarks
—
Required
By default, LACP is
disabled on a port.
Optional
By default, the port priority
is 32,768.
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in any
view
Available in user
view