Configuring The Interval To Perform Statistical Analysis On Port Traffic; Enabling Giant-Frame Statistics Function; Disabling Up/Down Log Output On A Port - H3C S5600 Series Operation Manual

Operation Manual – Port Basic Configuration
H3C S5600 Series Ethernet Switches

1.1.9 Configuring the Interval to Perform Statistical Analysis on Port Traffic

By performing the following configuration, you can set the interval to perform statistical
analysis on the traffic of a port.
When you use the display interface interface-type interface-number command to
display the information of a port, the system performs statistical analysis on the traffic
flow passing through the port during the specified interval and displays the average
rates in the interval. For example, if you set this interval to 100 seconds, the displayed
information is as follows:
Last 100 seconds input:
Last 100 seconds output:
Follow these steps to set the interval to perform statistical analysis on port traffic:
Enter system view
Enter Ethernet port view
Set the interval to perform
statistical analysis on port
traffic

1.1.10 Enabling Giant-Frame Statistics Function

The giant-frame statistics function is used to ensure transmission of network traffic and
to facilitate statistics and analysis of unusual traffic on the network.
Follow these steps to enable the giant-frame statistics function:
Enter system view
Enable the giant-frame
statistics function

1.1.11 Disabling Up/Down Log Output on a Port

An Ethernet port has two physical link statuses: UP and Down. When the physical link
status of an Ethernet port changes, the switch will send log to the log server, which in
turn acts accordingly. If the status of Ethernet ports in a network changes frequently,
large amount of log information may be sent, which increases work load of the log
server and consumes more network resources.
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
To do...
system-view
interface interface-type
interface-number
flow-interval interval
To do...
system-view
giant-frame statistics
enable
Use the command...
Use the command...
1-8
Chapter 1 Port Basic Configuration
Remarks
—
—
Optional
By default, this interval is
300 seconds.
Remarks
—
Required
By default, the
giant-frame statistics
function is not enabled.