Displaying And Maintaining Pos Port Configuration; Pos Port Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – POS Port
H3C S9500 Series Routing Switches

1.3 Displaying and Maintaining POS Port Configuration

Operation
Display all information
about POS port(s)
Clear the statistics of
POS port(s)
Enable/disable POS
port debugging

1.4 POS Port Configuration Example

I. Network requirements
Configure Switch A and Switch B to make them communicate with each other through
POS ports. Switch B provides the clock.
II. Network prerequisites
None
III. Network diagram
As shown in
POS 3/1/1, whose addresses are 202.38.163.10/24 and 202.38.163.11/24.
Figure 1-1 Network diagram for directly-connected POS port configuration
IV. Configuration procedure
1) Configure Switch A
# Create a VLAN interface with an IP address for the VLAN to which the POS port is to
be assigned.
<Switch A> system-view
[Switch A] vlan 2
[Switch A-vlan2] interface vlan-interface 2
[Switch A-Vlan-interface2] ip address 202.38.163.10 255.255.255.0
[Switch A-Vlan-interface2] quit
display interface pos
[ interface-number ]
reset counters interface pos
[ interface-number ]
[ undo ] debugging ppp { { ipcp |
lcp } { all | error | event | packet |
state } | all | core event | ip packet |
mpls-multicast packet |
mpls-unicast packet | osi-npdu }
[ interface { aux | pos }
interface-number ]
Figure 1-1, Switch A and Switch B are interconnected by POS 2/1/1 and
Chapter 1 POS Port Configuration
Command
1-8
Remarks
Available in any
view
Available in user
view
Available in user
view