Basic Vlan Interface Configuration - H3C S5600 Series Operation Manual

Operation Manual – VLAN
H3C S5600 Series Ethernet Switches
Caution:
VLAN 1 is the system default VLAN, which needs not to be created and cannot be
removed, either.
The VLAN you created in the way described above is a static VLAN. On the switch,
there are dynamic VLANs which are registered through GVRP. For details, refer to
"GVRP" part of this manual.
When you use the vlan command to create VLANs, if the destination VLAN is an
existing dynamic VLAN, it will be transformed into a static VLAN and the switch will
output the prompt information.

2.1.3 Basic VLAN Interface Configuration

I. Configuration prerequisites
Before configuring a VLAN interface, create the corresponding VLAN.
II. Configuration procedure
Follow these steps to perform basic VLAN interface configuration:
To do...
Enter system view
Create a VLAN
interface and enter
VLAN interface view
Specify the
description string for
the current VLAN
interface
Disable the VLAN
interface
Enable the VLAN
Interface
Use the
command...
system-view —
Required
interface
Vlan-interfac
By default, there is no VLAN interface on a
e vlan-id
switch.
Optional
By default, the description string of a VLAN
description
interface is the name of this VLAN
text
interface. Vlan-interface1 Interface for
example.
Optional
By default, the VLAN interface is enabled.
shutdown
In this case, the VLAN interface's status is
determined by the status of the ports in the
VLAN, that is, if all ports of the VLAN are
down, the VLAN interface is down
(disabled); if one or more ports of the VLAN
are up, the VLAN interface is up (enabled).
undo
If you disable the VLAN interface, the VLAN
shutdown
interface will always be down, regardless of
the status of the ports in the VLAN.
2-2
Chapter 2 VLAN Configuration
Remarks