Displaying Ip Addressing Configuration - H3C S5600 Series Operation Manual

Operation Manual – IP Address and Performance
H3C S5600 Series Ethernet Switches
Note:
This chapter only covers how to assign an IP address manually. For the other two
approaches to IP address assignment, refer to the part discussing DHCP in this
manual.
Follow these steps to configure an IP address to an interface:
Enter system view
Enter interface view
Assign an IP address to
the Interface
Note:
You can assign at most five IP address to an interface, among which one is the
primary IP address and the others are secondary IP addresses. A newly specified
primary IP address overwrites the previous one if there is any.
The primary and secondary IP addresses of an interface cannot reside on the same
network segment; the IP address of a VLAN interface must not be on the same
network segment as that of a loopback interface on a device.
A VLAN interface cannot be configured with a secondary IP address if the interface
has been configured to obtain an IP address through BOOTP or DHCP.

1.3 Displaying IP Addressing Configuration

Display information about
a specified or all Layer 3
interfaces
Display brief configuration
information about a
specified or all Layer 3
interfaces
To do...
system-view
interface interface-type
interface-number
ip address ip-address
{ mask | mask-length }
[ sub ]
To do...
display ip interface
[ interface-type
interface-number ]
display ip interface brief
[ interface-type
[ interface-number ] ]
Chapter 1 IP Addressing Configuration
Use the command...
Use the command...
1-4
Remarks
––
––
Required
No IP address is assigned
by default.
Remarks
Available in any view