Protocol Specifications; Gvrp Configuration; Enabling Gvrp; Gvrp Configuration Tasks - H3C S5600 Series Operation Manual

Operation Manual – GVRP
H3C S5600 Series Ethernet Switches
Normal. A port in this mode can dynamically register/deregister VLANs and
propagate dynamic/static VLAN information.
Fixed. A port in this mode cannot register/deregister VLANs dynamically. It only
propagates static VLAN information. Besides, the port permits only static VLANs,
that is, it propagates only static VLAN information to the other GARP members.
Forbidden. A port in this mode cannot register/deregister VLANs dynamically. It
permits only the default VLAN (namely, VLAN 1), that is, the port propagates only
the information about VLAN 1 to the other GARP members.

1.1.3 Protocol Specifications

GVRP is defined in IEEE 802.1Q standard.

1.2 GVRP Configuration

1.2.1 GVRP Configuration Tasks

Complete the following tasks to configure GVRP:

Enabling GVRP

Configuring GVRP Timers
Configuring GVRP Port Registration
Mode
1.2.2 Enabling GVRP
I. Configuration Prerequisite
The port on which GVRP will be enabled must be set to a trunk port.
II. Configuration procedure
Follow these steps to enable GVRP:
Enter system view
Enable GVRP globally
Enter Ethernet port view
Task
To do ...
system-view
gvrp
interface interface-type
interface-number
Required
Optional
Optional
Use the command ...
1-5
Chapter 1 GVRP Configuration
Remarks
Remarks
—
Required
By default, GVRP is
disabled globally.
—