Labmaster Setup; Connecting Labmaster Components; Pcie 1 Lane Cable Sync Connection(S) - Teledyne LabMaster 10 Zi Series Operator's Manual

Getting Started Guide

LabMaster Setup

Connecting LabMaster Components

LabMaster components are connected by PCIe 1 and 4 Lane, SMA 72",
and Power Cables. Use the following procedures to properly connect all
parts of your LabMaster.

PCIe 1 Lane Cable SYNC Connection(s)

Connect each PCIe 1 Lane Control Input on the back of your 10-xxZi
Acquisition Modules to a PCIe 1 Lane Output on the MCM-Zi Master
Control Module using the PCIe 1 Lane cable(s) provided.
PCIe 1 Lane Cable
On the back of the Master Control Module, plug one end of the PCIe 1
Lane cable into the PCIe 1 Lane Channel Sync Output (labeled SYNC).
LM10Zi-GSM-E Rev A 21