Table of Contents
Advertisement
9.4 Trigger Control
A. Opens the trigger setup dialog box
B. Auto mode: Triggers after a preset period if no valid trigger occurs
C. Single mode: Triggers once when all conditions are met
D. Normal mode: Triggers repeatedly when all conditions are met
E. Trigger level adjustment: Push to set the level to 50% of the waveform
F. Trigger status light, Ready or Trig 'd
9.5 Run/Stop Button
9.6 Auto Setup Button
Trigger ->Auto Setup.
1.800.561.8187
Press the button to switch the acquisition state between Run and Stop.
When the state is Run, and the button is illuminated in yellow. When the
state is Stop, the button is illuminated in red.
The oscilloscope will automatically set the vertical scale, horizontal scale,
and trigger level according to the input signal to get the optimum waveform
display. You can also perform an Auto Setup operation following the steps
www.
information@itm.com
.com
T3DSO2000A Manual. Page 27
Advertisement
Table of Contents
