Probe Dialog - Teledyne LabMaster 10 Zi Series Operator's Manual

LabMaster 10 Zi Oscilloscopes

Probe Dialog

Teledyne LeCroy proprietary probe interfaces provide a complete
measurement solution from probe tip to oscilloscope display. The Probe
Dialog displays probe attenuation and other information, and allows
you to make tip select and other probe settings from the oscilloscope
touchscreen.
The following figure shows a typical channel setup dialog on a Teledyne
LeCroy oscilloscope containing both ProLink (Input A, Upper) and
ProBus (Input B, Lower) interfaces. The input selection is on the left-
hand side of the dialog box. In this case the A input, the ProLink
interface, is selected.
When the probe is not connected, there is only a C1 tab selection for
vertical channel setup and the user has the ability to select input
coupling and probe attenuation.
Channel dialog showing Input A's interface controls setup before connection.
After a probe is connected, it is recognized and an additional tab with
the probe model name is displayed to the right of the C1 tab. Click on
the tab or the probe field to display the probe dialog.
Channel dialog showing Input A's interface controls setup after connection.
44 LM10Zi-GSM-E Rev A